Half-mirror for the coaxial surface illumination are built-in and movable.Zoom Telecentric system, Heat absorbing filter, Built-in cooling fan, Stepless brightness adjustment, Soft lighting (inrush current reduction), Bulb sliding mechanism.
Align the index dot of the projection lens with that of the lens mount, push the projection lens upwards, then rotate the lens clockwise approximately 60. After reading, retain it close at hand for future reference. Mitutoyo Profile Projector Pj 300 Manual Uses VariousSafety Precautions This manual uses various symbols to help you use this unit correctly, and prevent danger to personnel or equipment damage. Unplug the power cord and contact Mitutoyo if liquid has entered the instrument. Only hold the specified parts of the instrument if transporting. Exercise care so as not to pinch or hurt your fingers if mountingdismounting accessories. Information in this document is subject to change without notice. It can perform precision measurement of workpiece dimensions, contours and surface features. Mitutoyo Profile Projector Pj 300 Series Measuring ProjectorUse and store the PJ-A3000 series Measuring Projector in a place where it will not be subjected to dust and dirt. The PJ-A3000 series has been fully adjusted at the plant, therefore take special care when handling and setting up the projector so that no part of the projector is subjected to impact or vibration. Leveling bolts Carrying handles 2.1.4 Removing the carrying handles After setup, remove the carrying handles and cover the screw holes with the supplied hole. Focusing wheel Gently place the cross-travel stage on the mount. Slide the moving sections to the left and right to check the screw hole positions, then use the four hex-socket head screws (supplied in the standard accessory box) to temporarily fix the cross-travel stage in place. Installing the Digimatic Head Loosen the clamp screw and hex-socket head screw on the bracket. Slowly insert the stem of the Digimatic Head into the bracket as far as it can go, then secure it in place with the hex-socket head screw. Do not fasten the screw too tight, otherwise the spindle of the Digimatic Head will not move smoothly. Output connector Confirm sufficiently to connect so that the connection of X-axis and Y-axis may be not NOTE wrong. X-axis Y-axis Cable outlet cover Gently place the cross travel stage on the cross travel stage mount. Slide the moving parts to the left and right to align the screw holes, then use the four hex-socket head screws supplied to temporarily fix the cross travel stage in place. Connect the signal cables from the circuit board in the projector to the connector. Connector for Linear encoder The cross-travel stage should be secured when the adjustment of its travel direction is complete. Refer to 2.5.2 Aligning the cross-travel stage travel direction to the cross-hair lines.) 2 - 8 No.99MBA043A. Remove the cable outlet cover. Disconnect the linear encoder connectors from the P.C.B inside the Profile Projector. Attach the cable outlet cover. Connect the linear encoder connectors to the Optoeye A2 Counter. Hold the lens so that the red index dot of the projection lens faces you.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |